Clone Wars Z-6 Rotary Canon (spins too)

Jango 5204

Active Hunter
This is the 5th gatling gun I've done. They get better each time. The 1st one I made was 22 lbs. The next 2 were more accurate, but didnt spin. All of them have an intense blue LED. The 4th was more accurate yet and didn't spin. I was finally able to keep the weight down and get it to spin. Total weight is about 9.6 lbs. There a video of it working at the end. I'll be taking this to Wondercon and using it with my Camo ARF. The only thing I'm missing is the 6 nuts on the back circle. I'll get those on tommorrow.


P3141095.jpg

P3141096.jpg

P3141097.jpg

P3141099.jpg

P3141102.jpg

P3141098.jpg


VIDEO

th_P3141100.jpg
 
how much were you asking?


Apparently too much. The 1st versions took me at least 40 hours each to make. I figure if I want to get rid of them I need to come down to about $200, but even that might be too much. The only two I'm interested in selling at this point, are the 2 with the tube handles and the 3 ridges. Id didnt finished the handles cause it was clear they weren't going to sell, and I wansn't going to put another minute into something that was sitting in garage. So I dropped the price and they'll go as is. They still have a blue LED in the top center barrel.
 
Dude that's seriously very cool. If I were doing a clone wars style trooper I would be interested in one. So your saying you are asking $200 for one without the motor, but it has the lighting? I don't think your asking too much... They are pretty freakin' cool looking... ...maybe the problem was there isn't enough people making clone wars style troopers yet?
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top