The Clone Wars: Clone Trooper Helmet Templates

I've used a few techniques in scaling Pepkura models to fit my own head and body frame but somehow it seems t make a project that's....let's say normally 11 pages to print and after i change the scale after my math it says it's 100+ sheets. This can't be right. Anyone know of a great method to scaling Pepakura models better?

You might be getting your units mixed up... Pepakura works in millimeters (1 inch = 25 mm). Most Pep helmets out there are around 300 mm high but for this one you'd have to allow for the fin and go for, say, 325mm as a starting point. You might have to adjust the layout of the unfold a little if you're making a big change in scale.
 
Hey Skip your blog is not there when I clicked on the link or when I typed in the url do you know why if so could you tell me please. Thanks
 
Hey umm I made an account so I could download the files and make my own helmet. However I see he was last active 3 years ago and his blog link isnt working. Anyone know somewhere else I can get the files? :cry Thanx
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top