Hi Guys haven't been here in a while
Ok so I got a Rex voice changer helmet and have been wondering how to make it look better, I think everyone knows what these look like but just in case
OK so I have not done much cos I don't now what to do, But I have cut up pieces of paper & pasted them on it, Now it looks like this
On the picture the visor may look a bit small but looks accurate in person.
Ok there are parts of the helmet I have some questions about, Please help.
Just to let you guys know I have not done anything like this before so please try to keep things simple, Thanks
Ok this part
As you can see it has cracks or lines that connects the helmet together, Ok question: What do I use to seal the cracks?
What about these cracks? Or that big air hole at the back? Those black lines at the bottom left are actually holes, are they supposed to be holes?
Is there supposed to be a wire mesh behind to mouth? & The mouth is supposed to be gray right?
Is that squire thing supposed to be wire mesh too? or does it look fine? If it is supposed to be wire how do I cut that squire out?
Is that round thingy correct? I know the is vent is supposed to be black but is the vent correct? those curves at the bottom are inaccurate right?
It came with a rangefinder that was a bit bent any ideas on how to fix that
And is it supposed to come with a cap for if I don't want the RF?
Well that's all I have for now, sorry if I sounded like I was ranting, if there's anything I missed please tell me
Oh yeah I don't like the paint job, so how do I remove the paint & should I remove it before or after I've modded It?
Thanks Guys appreciate the help