Animated clone jetpack?

Darth Voorhees

Well-Known Hunter
Preferred Vendor
Does anyone make the jetpacks sometimes used in the clone wars series? Im building an animated clone, Denal, and he is seen sometimes using a jetpack, similar to Fetts. I thought it would be a great add on sometimes. Was curious if anyone had made one, or if perhaps i should give it a go based off the Fett templates.
 
I have a body of a JP made back home...its a tough one to do with the templates. Your handy Im sure you can get it done. I know some of them use one like jangos arena pack. Id like to see it happen.
 
Thanks man..yea i know i can do it using foamboard and bondo basically. Then i can take a mold off it. Im gonna see if i can get some good screen grabs and fabricate one.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top