ANIMATED CLONE BOOTS "MY WIP"

crow62

Active Hunter
Hi again brothers, finally my toon shoe design, thanks by the PM´s sent to me with your pics and comments over How the animated clone trooper shoe should to be.

The lasts was the hard part, I had to wait christmas and new year to recieve the lasts (12 pairs from 8.5uk to 14uk Szs), here a comparition with the live version:
17012011_005.jpg


The last for toon has to be square toe and really widht:
17012011_006.jpg


I started with the partial impression taking:
17012011_008.jpg


after both sideS, is turn to design the central detail:
17012011_010.jpg


time to draw the future leather stencils (I could use the PC assitance but is more exciting the handy design):
17012011_013.jpg


after cut and sew the leather pieces here the result:
18012011_004.jpg


time to start forming the shoe, first the basement:
18012011_023.jpg


after some steps, almost finished:
18012011_025.jpg


One close up of the final stage work:
18012011_020.jpg


Sole Time: I have to scale the visual references to achieve the visual pleasance:
20012011A.jpg


continue...
 
the next pic is the beta version, I rejected because the zipper is so back and the height was not enough:
18012011_015.jpg


And here with the unfinished shoe (This was the beta version)
20012011_002.jpg



IT´S A PLEASURE TO ME ANNOUNCE THAT:
THE FINAL DESIGN it is glued at the sole, I´ll wait the sunlight to make better photo takes tomorrow morning.

I hope you enjoy the pics.

Giovanni
crow62
 
Very nice work Giovani. Did you resolve the rivet vs sewn strap? Have you considered using a snap for the strap? Thx for the pics.
 
Last edited by a moderator:
Very nice work Giovani. Did you resolve the rivet vs sewn strap? Have you considered using a snap for the strap? Thx for the pics.
Thanks Thrax, will go with velcro, because the width sizes feet variations, in the animated as you can see the disc strap has big diameter that is good because will hide the most part of the inner zipper.
 
And here is the finished boot:
21012011.jpg


here is the inner side, the disc strap will cover mostly zipper:
21012011_003.jpg


without the strap is so easy put inside the foot:
21012011_002.jpg


Here, you can image how will look inside the armor:
21012011_005.jpg


The pic for reference(look the virtual draw mistake on the strap):
reference.jpg


and my finished job:
21012011.jpg


If your animated armor came with hard strap, you just will avoid my disc and the strap, the main will go with velcro.

So, if you want a pair, I will put a run in the Sale forum tomorrow Monday, I am making the accounting issue to calculate the final price.

Thanks by your comments.
Giovanni
CROW62
 
Last edited by a moderator:
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top