What is the best way of bending the collar plate?

Revan

New Hunter
This is my first atempt at bending armor. What is the best way to go about bending a collar plate made from 2mm aluminum?

Collar Plate.jpg
 
Wow! When I was working on metal armor a while back I tried to just bed it with my hands... I had two subtle lines where the metal was stressed. This looks great!
 
Good job!
Ideally, you want to "Roll" the metal over a smooth round/tubular surface. This keeps you from getting creases in the metal.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top