Vacuformed Female Chest Plates

Memory

New Hunter
Edit:

Normally I only dabble in metal work (and only post on the Mercs forum as Vhe'dn Oyre), but I recently took a shot at building a vac table and came up with this, roughly cut out with minimal finishes:

DSCF0500.jpg


Looking at the above picture, down the middle from top to bottom of the plates measures about 7 1/2 inches. Across the widest part of the chest over both plates, laid out like this, measures about 11 inches. I'd place these at a C/D cup size. Band size I'm a bit iffy about, but they're probably made to a small/medium frame.

DSCF0501.jpg


DSCF0502.jpg


DSCF0503.jpg


My vactable set up, with an earlier failed version of a mold:

DSCF3650.jpg


I'm very happy with how this second mold turned out. :)
 
Last edited by a moderator:
Not looking bad at all, you need to get rid of the "Pepsi sign" shaped ridge on the left breast and perhaps neaten up the diamond, but feel free to ignore me, I live in perfectionist world, so I'm a bit on the pedantic side :)
 
Two things:
1. What Saz said about the ridge. Shouldn't be a huge problem to fix and you know you did a good job when the only complaint is this nit picky :p
2. Be ready to have to clean out your inbox hourly from all the PM's you'll be getting;)

Have a good one,
Hagen
 
She has already fixed the ridge in the mold. I agree with you on #2 Hagen. I definitely plan on ordering a set for my gf if she plans to go public with these.
 
D'uh now don't I look stoopid, missed the comment above the boobs!

Now that sentence just made me look worse.

I'll get my coat!
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top