Tearing out innerds of bike helmets?

Tora Rall

New Hunter
just as the title says.

just got a bike/skateboard helmet to use as a dome for my new and better bucket but I'm not sure how to go about gutting the darn thing.

Any help please?
 
The foam is glued in with hot glue in several places. you may need to cut into the foam with a craft knife, it needs to be a sharp blade, once you have enough cut off you should be able to pull the rest out.
 
Hey cool idea, I was going to use a hard-hat liner like I have in my Biker Scout bucket...but I like this idea too. Anyone got pics?
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top