lerxstrulz
New Hunter
Hey All,
I messed around with the ZipZap tutorial and decided that I would build an RF servo kit using a couple Arduinos and a 433Mhz Transmitter and Receiver (TX/RX). I put it on a WIP bucket for Halloween and went as "Island Mando" Video and pic below. The units are on proto breadboards for now but plan on etching a couple PCB' s in the next week or so to make the setup a little more compact. I also have encoded the TX/RX to each other so there will be no accidental triggering of the stalk It currently uses a single button (the board remembers what position it is in and goes the other way) and I have plans to add a couple micro potentiometers to adjust start and finish positions.
I messed around with the ZipZap tutorial and decided that I would build an RF servo kit using a couple Arduinos and a 433Mhz Transmitter and Receiver (TX/RX). I put it on a WIP bucket for Halloween and went as "Island Mando" Video and pic below. The units are on proto breadboards for now but plan on etching a couple PCB' s in the next week or so to make the setup a little more compact. I also have encoded the TX/RX to each other so there will be no accidental triggering of the stalk It currently uses a single button (the board remembers what position it is in and goes the other way) and I have plans to add a couple micro potentiometers to adjust start and finish positions.
Last edited by a moderator: