Mando helmet

alleycat88

New Hunter
First off just wanted to give props to WoF for the templates. This is my first try at a helmet. I am trying to use my abilities with sheet metal to create it. Here are some pics of what I got done so far. I will post more as I get more done. For my dome I will be using a blading helmet I had laying around. Thanks for any comments or questions if you have any for me.

Picture-various 907.jpg


Picture-various 909.jpg


Picture-various 911.jpg


Picture-various 913.jpg


Picture-various 916.jpg


Picture-various 917.jpg
 
Yeah that is what im using also. Just picked up some from a tractor supply store. It comes in 2' square peices which is easier to work with then a full sheet from a metal supply company.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top