Mandalorian Pilot Project

Piotr, would you consider doing a run of those helmets to sell? I am sure they would go quickly.
 
Yes. I want to make molds for this helmet. I must know how many peoples want to buy this helmet because it will be very expensive for me to prepare molds ( a lot of silicone must be used to prepare molds). It will be set of big amount of parts (helmet, cover of bell, ear panels (bottom and top parts), RF module etc. The term of preparing molds - december/january. Now I'm doing current run of mando helmets and I'm preparing to make molds for my Z-6 jetpack (http://www.thedentedhelmet.com/f20/z-6-jetpack-made-scratch-47419/ ). It will be available soon.
 
Awesome, I'm sure others will want one. Great job on the suit.
 
Pretty b@d@$$ Piotr, nicely done.
You really blended the real world military look with the originality of a Mando pilot. I love the chest armor and how you kept it light, very functional and believable as a real look. I also really dig the tubes going up into the back of the helmet from the pack, that was a nice nod to the AT-AT driver. I can tell you put some thought into this costume. Great work and looking forward to seeing more from you in the future hopefully. :cheers
 
THX a lot :). No, red cover is separate part, but don't work as blast shield. I want to make it as separate part, so it will be possible to make it in this way :).
 
Some artworks about my pilot :)

running+mando_FHD.jpg


running_FHD.jpg



And "My" A-wing during the Battle of Mindor :)

Mandalorian+A-Wing+Card.jpg
 
The more times I look at this post the more I want one of those helmets. Again Piotr, fantastic job.
 
Yes. I want to make molds for this helmet. I must know how many peoples want to buy this helmet because it will be very expensive for me to prepare molds ( a lot of silicone must be used to prepare molds). It will be set of big amount of parts (helmet, cover of bell, ear panels (bottom and top parts), RF module etc. The term of preparing molds - december/january. Now I'm doing current run of mando helmets and I'm preparing to make molds for my Z-6 jetpack (http://www.thedentedhelmet.com/f20/z-6-jetpack-made-scratch-47419/ ). It will be available soon.

Do you have some idea of the price you want to receive for a kit of this helmet?
PM if you like. :)
 
That is sweet, you really do come up with some good ideas for props.
 
Awesome. Looks like you two are having fun. Great job on his suit too.
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top