Mand'alor the Ultimate's Build

MerCenary

Jr Hunter
I have been working on the Mandalore the Ultimate's Chest armor and left pauldron, here are pix of my WIP.

Still lots of progress to do on this left pauldron :/

pauldrons001.jpg


pauldrons002.jpg


pauldrons003.jpg


pauldrons004.jpg


This one me beside it to see the dimensions?.....

pauldrons11.jpg



My Chest ARMOR:

metarm005.jpg


metarm002.jpg


metarm003.jpg


Under part.
metarm004.jpg



What do you think?
 
Last edited by a moderator:
What guage are you using? Looks to be 20-22? The chest looks really good, I think you nailed that part.

There is something about the small segment on the pauldron that looks a little off center. Maybe it's the angle of the picture. Nice metalwork so far!!!
 
Last edited by a moderator:
What guage are you using? Looks to be 20-22?


I dont know what the guage is but it is 2 MM thick.

There is something about the small segment on the pauldron that looks a little off center. Maybe it's the angle of the picture.

That part is not off center, it is the top side part above my hand that needs more trimming.
there is 1/4 of an inch at the top to 1/2 inch at the bottom ,so I need to cut it slanted (/).

I still have lots of work to do on that piece.
 
Last edited by a moderator:
Thanks all,


After I complete all parts of my costume, they will be painted all together at the same time....thanks


Completed to my taste and ready to paint !

What do you think my fellow vode ? Honest opinions good or bad . ???

pauldrons22002.jpg


pauldrons22001.jpg


pauldrons22003.jpg


What do you think ?
 
Last edited by a moderator:
Forgot to add,

There is still the 4 slots like holes to add on the top part of the pauldron, but I will probably just make some painted bar like stripes and see what it looks like.
 
Last edited by a moderator:
2ND PAULDRON

My right Pauldron Armor WIP that I started today did.nt have much time though the shape it done.

I need to straighten some parts and a bit of bondo in 2 corner's were the curved parts are..

PLUS , I need to add that top mohawk thingy on the pauldrons upper middle part. :)

Here is the progress so far...

pauldrons3001.jpg


pauldrons3002.jpg


pauldrons3003.jpg



pauldrons3004.jpg


How's that for MY FIRST TIME working on metal armor WIP ?
 
Last edited by a moderator:
OK,

Here's a little teaser ;)

I don't have my red cape yet but I took a blue bed sheet I had to show a bit how its going to look.

I have not fitted and restrained the parts for the suit till I paint and finish it. That's why I'm holding the chest and abdominal & mask parts together and loosing my codpiece because I dont have a third hand !

The left bulky pauldron needs to be adjusted on its mount....... :-\ A bit to high to my taste

I am presently working on the codpiece and abdominal plate as seen on these pix.



mesuitup003.jpg


mesuitup002.jpg


mesuitup001.jpg



Any comments is appreciated, good or bad.

Thanks
 
Last edited by a moderator:
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top