How to attach jetpack

SKIDD

Jr Hunter
Ok I'm making coustom armor and I'm not sure on how to attach the jetpack to the armor? Any sugguestions? :confused Please help.
 
Depending on how heavy the jetpack is, you can also directly attach it to the backplate, which works really well as long as the backplate is solidly attached to your flak vest.
 
Ok, so the harness goes through the back plate. Is the harness atached to the back plate or flak vest. Or is it just worn under the flak vest and it goes through the vest and back plate?
 
Ok, I understand now. So I'm guessing the jet pack attaches to the harness with clips or D-rings and hooks or something? BTW do you put the harness on first and then feed straps through the vest and back plate or does the harness go through the back plat from the outside so when you put it on you slip on the vest and stuff and fasten the harness then close up the flak vest? Also, this has nothing to do with the jetpack, but what do all the different Fett types mean? (eg) ROTJ, ESB, ect. I'm just wondering.
 
I bought a cheap camel back and added nylon straps with plastic snap buckles pull them thru the vest and backplate and someone snaps the plastic buckles on my jet pack to it cost was like $20 bucks
 
plastic snap buckle buy at any craft store

Add Content

image.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top