Custom Mandalorian FX for Woodchuck Blasters (Noob Build)

Draco705

New Hunter
Hello, all!

This is my first build and I really wanted to do a good job, especially since I managed to get a Woodchuck DC-15s Sidearm. I want to add some FX to it besides just painting and I had a few questions.

Here's what I want to add:

2 LEDs
- 1 at the muzzle for "blaster fire" slaved to a board so it flares when I pull the trigger
- 1 at the center section to glow when the system is turned on

1 speaker/sound board to be slaved to a switch already built into the trigger (Thanks again, Woodchuck!) that sounds off when the trigger is pulled

1 extra on/off switch to control the overall power

I looked at Plecter Labs, and even sent him an email, but he says it'll be a while before he does any more Blaster Core boards. DAE know of a good manufacturer for sound/light control boards? I have thought about using an Arduino Micro, but I'm not sure how that's going to work.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top