Comic Death Watch Helemt Sculpt

Aden Bishop

New Hunter
Well due to a week of winter madness here in Maryland, I have had some time to get back to work on my Death Watch helmet sculpt. The helmet measurements once cast should be close to the “mystery bucket” since I used my modern helmet as the reference for this. Currently, I am concentrating on getting the symmetry correct and details then will move on to smoothing it out for the first mold and cast. Hopefully, I will have this done by the end of the month so I can start working on my modular gauntlets and some major Mass Effect props. Let me know what you think.

dw_front.jpg

dw_r_side.jpg

dw_l_side.jpg


A’den Bishop
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top