Alt. Mando bucket

Started to coat it with resin to stiffen it up a bit and seal the seams. :D

13355_1137139161487_1617603295_380721_6195870_n.jpg


13355_1137139201488_1617603295_380722_6214978_n.jpg


13355_1137139241489_1617603295_380723_6654539_n.jpg


13355_1137139281490_1617603295_380724_3355699_n.jpg


-Jason
 
okay going to go get sponge brushes today to finish the resin coats also going to fiber glass the inside and make the dome. hopefully will be sanding tomorrow. if i keep on track this maybe done by the end of next weekend. keep your fingers crossed. :D

-Jason
 
1st coat of resin is complete. in a few hours i'll put 1 more coat of resin on then fiberglass the inside. just printed out the templates for the dome will be starting on that once i'm done with this post. :D

13355_1137542931581_1617603295_381584_1184557_n.jpg


13355_1137542971582_1617603295_381585_4025939_n.jpg

13355_1137543011583_1617603295_381586_4585731_n.jpg


-Jason
 
Lookin Good, looks like your Still Goooooo-ooood Jason, Niiiii-iiiice Jason

Also An Idea, MAke a jet PAck like thing, for maneuverbility underwater and in the center, your oxygen Tank
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top