Signature Picture Not Showing?

HeadlessHunter

Well-Known Hunter
I just created a small Sig picture based on a few helmets I have built/painted but it doesn't seem to be showing up, I uploaded it from my computer and didn't get an error message saying it was too big or anything, help? :lol:
 
Ok first off check the file properties it may not dispaly and error message? They need to conform to this

Note: The maximum size of your custom image is 728 by 90 pixels or 50.0 KB (whichever is smaller).

If it works the image shows as a preview when the upload is successful.
 
That is odd! I had an issue where my pm's were going blank. I closed down fully my browser and re-booted, the problem went away. Also, when I had that isseu the boba image at the top of each page failed to load?

If you keep your browser open and/or hibernate your machine maybe that is part of the issue?

I assume you saved changes?
 
Hmm wonder if I can link to it here?

EDIT - Nope, grrrr!!

SIG.JPG
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top