Where to cut this helmet

Jangojack350

Jr Hunter
I was wondering where i should cut this helmet so that i could then clip it back together when its on my head. Similar to some storm tropper helmets and vaders helmet.

<a target='_blank' title='ImageShack - Image And Video Hosting' href='http://img707.imageshack.us/i/helmetport.jpg/'><img src='http://img707.imageshack.us/img707/8813/helmetport.jpg' border='0'/></a>

Helmet port..jpg
 
Last edited by a moderator:
id cut it where the rear plate is, similarly as stated above, and then I would extend the remaining portion down an inch so that the rear can 'fasten to it (technically over it).
 
mask.jpg


If it were me, I would break it into two pieces, and add a lip as shown in orange. Then after putting the mask on.I would slide the back around.
 
you can get them on the internet or at hobby stores, they REALLY stick together TIGHT. Or you could break open an old hard drive thats junk, it has one of the strongest magnets ive ever seen in them:)
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top