shaping the backplate

To those of you who made your own sintra armor, how did you go about shaping the backplate? It's too large to fit in a pot or pan of water, and I don't have a heatgun. Any suggestions?
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top