Rorschach Mask Possible?

Any suggestions for techniques on putting seeing holes in it?

This is what I did, and it worked perfectly.


  1. Put the mask on right side out
  2. Have a buddy mask sure the blot is on your face correctly
  3. Put pieces of scotch tape over the mask where you eyes are
  4. Take a marker and mark the exact place of your pupil on the scotch tape
  5. Carefully remove the mask
  6. Cut a small mark through the tape and mask where you made the mark.
  7. Remove the tape
  8. Gather up a small bit of fabric by pinching the sides around the newly made cut
  9. This makes a little bump with the cut on the peak
  10. Cut this peak off
Now you have a perfect hole! Hopefully steps 8-10 make sense. Just visualize what I wrote and you'll get it.

Kody
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top