remove paint from smooth cast roto?

Kwally89

Hunter
I got a bucket I was doing some paint testing on and realized I need to remove it. What method or compound should I use so it doesn't eat the plastic?

Thanks guys!
Kody
 
So it's resin, isn't it? Well, for the resin ones, like the SgtFang's helmets, I have used acetone and it has worked really well, so try it. Others have used it for remove the paint of the MR helmet.

(y)
 
i've used acetone on roto... it will eat thin spots (say, the keyholes on the back if you've trimmed them already), but overall it's not harmful if the resin is thick. i'd use caution, but it would probably be ok.
 
Careful sanding should also be considered if you don't want to risk damaging the plastic, whatever you decide take your time, that is the best advice I can offer (y)
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top