NURTS!!!!!!!

morpheus1977

Active Hunter
:confused :cry well while trying to pry the front plate off of my ranger finder I snaped it(the range finder that is )right off of the RF stalk. whats the best way to reattach it? I am thinking apoxy??
 
what I did on mine was drilled 2 holes through the stalk and into the range finder, filled them with JB Weld and used a couple of metal pins just to solidify it. once the JB Weld dries file off the pins flush with the rf stalk then fill the holes the rest of the way with JB. however I'm only explaining what i think you're asking.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top