My Fett helmet display stand

matt black

New Hunter
Hello everyone,
Just wanted to share my display stand that I just finished. It's the first time I have dabbled in electronics so was good to learn something new. I fitted the chest lights and RF lights in the front, switches in the side and orange LED's in the back to light up the wall and hopefulley give a bit of a carbon chamber vibe.
The weathering looks a lot better in person. It didn't come out good in the pics for some reason. I just thought this would make a cool little display.
All the best,
Rob.
001alvl.jpg

By bsac15 at 2012-01-17

002fjf.jpg

By bsac15 at 2012-01-17
003ppq.jpg

By bsac15 at 2012-01-17
006yex.jpg

By bsac15 at 2012-01-17
004eo.jpg

By bsac15 at 2012-01-17
 
Thank you. It's a helmet stand that I have had for a while now but I only used the pyramid part and built the rest from scratch and added a wooden base as it wasn't very stable. I also made the pole adjustable. The helmet should be here soon and I have decided to add a neck seal just showing at the bottom of the helmet so we will see how that looks. I will post more pics as soon as it arrives.
 
Thanks mate! Still have a long way to go as well. Need new jetpack, gauntlets and blaster. And last a new helmet some day. But at least I know it'll be good once I finish. No shortcuts. :)
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top