Molding. I have no idea!

I am about 50% done with my new gaunts and I want to make them into molds. How is this done? What do I make the molds out of and what do I use for the product? Also whare do I buy the stuff and about how much is this going to cost me?. Later I want to do my new JP.
 
Try searching for the tutorials, those are some hefty questions.

The short is : Silicone rubber and resin or fiberglass, alumilite.com and about 100-300 bucks depending on how thorough you go and the type of mold.

alumilite has quite a few nice tutorials. Go there and check out how the do the 'toy car body' because thats how you will want to do your mold. Only youll want to do a brush on, instead of block beecause block uses a tun of silicone. Way too much.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top