Molding and casting in rubber?

bobagoat

Well-Known Hunter
Anyone know anything about this?

Can you make a mold for rubber casts in the same way you would resin molds?

I've got some metal items I'd like to cast in rubber for safety's sake and so I don't get hassled by various over zealous con security types.

Any help?
 
What are you using for the molding rubber? I don't see why you wouldn't be able to use a negative silicone mold but you may have to use a mold release spray. It will all depend on the chemical makeup of the molding & casting materials you use.
 
I would think it wouldn't be any different than building a mold to resin cast. You just have to be careful with casting with the same rubber you made the mold out of. Use use mold release liberally, and make sure you use a silicone-free release if the rubbers are silicone, else you'll glue them to one another.

-Chris
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top