Making Fiberglass Homemade Gauntlets?

  • Thread starter Migrate from As You Wish
  • Start date
M

Migrate from As You Wish

Guest
I'm just wondering if it would be possible to make a basic shape for a gantlet out of cardboard or tag board and then covered it with fiberglass sheets, if that would work? I know nothing about fiberglass. Would it harden smoothly on the outside? Would it be strong enough if I fiberglassed around the entire thing?
 
It would work, however to apply the fiberglass in that way is very time consuming. When you lay the fiberglass over the cardboard you will be left with a very inconsistant surface. Very bumpy and uneven. You will then need to sand it down and then put some more fiberglass down in the thin spots. Then you will sand some more and fill some more spots with bondo. Then you will sand some more.....you get the idea. I did this with my helmet. It may seem dificult to make a clay sculpt and cast it in plaster then make a fiberglass cast....not really. The difference between the two procedures is that when you make a cardboard model and cover it with fiberglass, you are left with something that you are not sure how it will come out, and you spend about 2 weeks on it, any changes you want to make are difficult. When you make it out of clay, you spend the week sculpting it, any changes take a few min. you know what it will look like and once you have it cast, the fiberglass can be layed down, after about 6 hours pull it, then the next day sand it down. When you do it the other way you will sand FOREVER. The second way you will do little sanding. If you want any more info PM me.
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top