Jango Cod piece

dansam

Hunter
I spent ages looking for a Jango codpiece for sale but couldnt find one so I decided to do a scratch build myself,
Comments for improvement most welcome as I am new to this, well I have a creative background thats about it lol(y)

IMG_0488.jpg


IMG_0489.jpg


IMG_0490.jpg


IMG_0491.jpg


IMG_0492.jpg


IMG_0493.jpg


IMG_0494.jpg


IMG_0495.jpg


IMG_0496.jpg


IMG_0497.jpg


IMG_0498.jpg


IMG_0499.jpg


IMG_0500.jpg


IMG_0501.jpg


IMG_0502.jpg


IMG_0504.jpg
 
Right Mould made and first Cold Cast done, I think it dipped a bit not sure, anybody think its worth doing a run if they come out okIMG_0516.jpgIMG_0518.jpgIMG_0523.jpg
 
Right!, second attempt i was right there was dipping in the center so I have reinforced the mould with fiberglass, and the first one is out and looking good just needs a polish and should be ready to start producing 1 cc cp.jpg2 cc cp.jpg
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top