Home made Borden connector

DarthPestilence

New Hunter
Didn't want to spend money on a Borden connector so I found a bold lying around my shop that was about the right side and drilled 3 holes into it and threaded it into the cheek. Bondo and primer isn't finished yet. Just wanted to show off my engineering skills haha
 
Forgot to attach the picture. Here it is
uploadfromtaptalk1406580865100.jpg
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top