Got 3 mannequinns

sithlordharley

New Hunter
ok so from my job i got a full mannequinn and 2 torso mannequinns.. ive never made a props before.. but do have dremel experiance(not that im good at it lol) but was just tryin to find some ideas or kinda guidance into making so sweet star wars busts any input would be awsome... also not looking to spend tons of money makin these either lol
 
CIMG0372-2.jpg

CIMG0373-2.jpg

CIMG0374-2.jpg
 
Some ideas...maybe nothing new or special :(

- wrap the torso with some sheets of foam (not too thick). Then accentuate some forms with a sharpie maybe.

- extend the arms a bit and fill the resulting gap between the arms and the torso with foam...this way you can achieve wider shoulders.

- cut off the hands and make some cheap posable ones...a piece of wood, some wire and some plastic hoses will do the job. Add foam to the fingers in order to achieve the desired thickness.

- cut the upper and the forearm where they join. Rejoin them with an existing or custom made ankle so the forearms are posable as well.

Materials for this wouldn't cost a fortune.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top