General Mando Build Advice

Thread starter Shiny94
Start date Apr 11, 2014

Shiny94

New Hunter

Apr 11, 2014

I have not done a mando build before. The extent of my building experience is a small clone trooper armor set for my niece, and a few prop repaints.

My biggest question is sizing, and placement of the plates.
Im 6'3 with a skinny build, and the templates ive found are all too wide to fit properly. Should i go with a smaller chest plate template and beef up the belly plate, or just downsize it all and try and compensate with a bigger belt?

Any and all advice is helpful
Thanks!

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.