Full-Size, usable Speeder Bike

Here's some more pics that should help....

spbike.jpg

spbike2.jpg

spbike3.jpg
 
Thank you Very much.......school has caught up with me, so unless i can find a large format printer that oesn't charge 10K for 11 pages, or someway to blow up the templates, but keep them on a letter sized piece of paper, then i am sunk for a bit........
 
Thank you Very much.......school has caught up with me, so unless i can find a large format printer that oesn't charge 10K for 11 pages, or someway to blow up the templates, but keep them on a letter sized piece of paper, then i am sunk for a bit........

I had to print out some big/scale blueprints for an old project a while back and ran into the same problem for scale prints it can get VERY expensive (especially if you want the blueprints actually blue with white lines) I ended up just printing it with a normal printer on multiple pieces of paper and taping them together with wide masking tape on the back, did the job perfectly and that way I wasn't bothered about folding it up or getting paint and glue on it etc hope that helps?

Oro
 
cool idea for a motorized life size speeder. my friend and i have been working on a life size speeder out of a bicycle. we hope to be done with it soon.
 
I just read this whole post and I did not see 1 progress pic. I guess this never happened. Plus this was started in 2009. Very disappointed.(n)
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top