Fixing a Resin Blaster

Ordin

New Hunter
Hello Everyone,

I have a Resin Blaster Carbine that has a few parts broken off. They are clean brakes and I was wondering what would be the best glue to attach them back to the mold?
 
You may have to add some support rods between the pieces other wise it may just break again ( as it will be the weakest point and thing always break at their weakest points :lol:)
super glue will be faster when bonding, but I find its brittle, two part epoxies are slower but are slightly more forgiving under strain. Only down side to epoxy over super glue is its thicker whereas super can almost hide the break
 
The plastic weld is a great idea. I would definitely use a support rod when gluing these pieces back together in the thick areas. Get yourself an 1/8" or 3/16" rod from home depot or lowes. Anything bigger than that wont flex well if your holes arent perfect. drill your holes, fill them with adhesive and put your rod in one side. Let it set and repeat the process in the other, spreading adhesive anywhere you can. E6000 might be good as it has a little flex. For the thin areas, use a 5 second fast set superglue or plastic welder. All of this stuff you can get at HD or lowes.
 
This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top