first time weathering question

saltydog81

Jr Hunter
ok so im done with making my first helmet (ok mostly done) and im ready to paint so i put a metallic base down and im planning on clear coating it to death then painting two more colors over that then sanding the "weathered" areas then clear coating it all again... will this work? is there a better way? i could use the advice of all you weather-ers out there :)
 
ok so what im looking for is some advice on subtractive weathering specifically ... no one seems to be on right now so im bumping this in hopes of a response
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top