ESB EE-3 chrom tip question

I just finished weathering my Dankenman sidearm tonight using wash of Tamiya Flat Black acryllic that I applied quite liberally and then wiped away with a tissue. I let some areas dry longer to give that carbon-scored look. I then added a very thin wash of Tamiya Flat Brown to give the hint of rust/oil before lightly sanding with 120 and 1000 grit sandpaper. I know you asked about the EE-3 and not the sidearm, but I plan on doing something similar (or maybe not quite so heavily weathered) with the EE-3. This is one of Dankenman's "seconds" so I intentionally went a little heavy with the weathering; I'm planning on being a lot easier on my Mojo (the grip of which is visible in the top of the frame) when I get to it. I highly recommend both, BTW.

DSC_0079.jpg


Here's the rest of my Boba WIP: Boba Fett WIP pictures by MarkusFett - Photobucket
 
Last edited by a moderator:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top