Doctor Doom WIP

Igniitus

New Hunter
Number one... I've been watching this Forum for a long time before finally registering... You guys are all incredible.

Number two... this is something I'm working on. I've been looking online and haven't seen that Many Doc Doom costumes out there... My budget is pretty low, Diapers are expensive and all.

I built the Mask on the base of a cheap "300 Spartan" Mask I found at a Halloween Store, and have added layer upon layer of think poster board until I've gotten it to where it is. The First two pics are from last week, the last two are from this morning.

Still needs to be painted, and still need to go buy the rivets to add to the mask. This week, I'm working on the Gauntlets.

Any feedback or tips you guys have would be appreciated!

PIC-0171.jpg


PIC-0170.jpg


Photo0084.jpg


Photo0086.jpg
 
Cap'n Crunch, Cheez-It, Fruit Loops and Pop-Tart Boxes... and a trusty Stanley Hot-Glue gun!

I bought Carpet Tacks at the Home Depot today, so I'm adding the "Rivets" now.
 
Few coats of paint and sanding later... still have to take a razor blade and cut off some of the protruding glue, etc.

PIC-0181.jpg


PIC-0180.jpg


PIC-0182.jpg
 
Ok, Mask is all done! Just have to put some foam on the inside for comfortable-ness sakes.

Now I've got to figure out the Gauntlets and such, but Now, to move on to the Cloak.

done.jpg
 
This the best Dr. Doom mask I've seen yet. I've been hopeing to find a Pep file for him but so far so such luck. Great work!!!
Clif
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top