Attaching Rubber to ABS ? what to use?

slave1pilot

Well-Known Hunter
I need to attatch my Stormtrooper Brow trim to my Bucket.
The trim I have is real rubber & the helmet is ABS.
What should I use to do this?
 
Hot glue? or two part epoxy?

I guess you should use ABS glue but i don't know if that will melt the rubber.. try it out on a small peice first.

Good luck
 
I have real rubber trim on my TK bucket and I used double-sided tape. Even when it's been exposed to a hot environment, it hasn't come loose.

Wes
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top