These light kits are designed to fit the Asok and Animefan RF toppers. They run on a 3v coin cell battery (either the 2025 or the 2032). They are self contained and do not need a hollow stalk. There are 2 red LEDs that alternatively flash on the back of the board behind the tilt switch.
In the second pic, the area where the pen is shows where the Rf topper will need a bit of sanding to get the kit to fit properly, this is due to the type of tilt switch used and the excess resin in the toppers, as well as a little sanding around the inside of the red LED holes.
The vids below show the two versions I will be building; one with a white LED and one with a green LED. While not movie accurate, I like the green one and it is also the one I will have in my own FP lid. The clear piece in the vids sits inside the topper with nothing added to help hold it in, but I plan on using a small magnet or piece of Velcro to make sure it doesn't fall off.
They will be $55 including shipping (USA), for international shipping, send me a PM and I will get the shipping cost figured out. PayPal only. PM me with info about which one you would like and when I have kits ready to go, I will send out my PayPal information. I do it this way to make sure that no one pays before a kit is ready to get shipped to them.
When you send me the PayPal payment please include your TDH Name , shipping address, and which kit (white or green) you would like.
1.Eaglewolf570 (2) Shipped 1312 1810 0000 2627 5937
2.Sgtski Shipped 9114 9011 5981 5872 1564 61
3.tzhan (2) Shipped
4.topcop28 Shipped 9114 9011 5981 5872 1578 57
2.ZeroGinc Shipped 9114 9011 5981 5872 2394 92
3.Eaglewolf570 (2) Shipped 1312 1810 0000 2627 5937
4.Brandontrueblue Shipped 9114 9011 5981 5872 2390 27
6.Masterblaster Shipped 9114 9011 5981 5872 2390 41
7.JTfett shipped 9114 9011 5981 5872 1950 71
9.Datathief Shipped 9114 9011 5981 5872 1591 65
10.Mainst69 Shipped 9114 9011 5981 5872 1748 30
11.Simon Kenobi Shipped
12.5326commcando Shipped 9114 9011 5981 5872 2222 10
13.Zebrabuse Shipped 9114 9011 5981 5872 2221 97
I just found out from WebChief on the bounty hunter's guild (he is the detachment leader) that the new Boba Fett ESB CRL lists the perspex light as white, and the ROTJ is green for level 2/3 approval. This information as of right now is correct, but I will keep an eye on the CRLs for any changes. As for prior sales, I would discuss the light with your 501st adviser and make sure you let them know that the final decision was not made until after the circuits were built and sold. If it becomes a major problem, I will most likely offer a swap out of the LED for those who are looking for level 2/3 501st approval. I don't have a plan set in stone, so once I have it figured out, I will let everyone know.
These light kits will also fit the toppers that come with the helmets made by animefan and this will be an ongoing run.
I also made a slight change in the board, the ones that I will be offering from now on are a little smaller and the Perspex led is more in the center of the Perspex piece.