sniper rifle base

Sorta looks like the one I posted, but that stock looks longer than mine.

Should work.


Edit: Here's the picture:
CIMG0848.jpg

It used to have the gold bans around the barrel and the stock and had the same orange tip. I think it was my brother's gun when he was a kid.

There's no brand or anything on mine, just has Davy Crockett on the stock and a sticker that says something like "Made in America, by Americans".
 
Last edited by a moderator:
Looks ok to me apart from the silver (we paint it black) breech plates. A greeblie hides them anyway though
The stock is more curved too. Looks almost graceful.

You could sand them down anyway?

Here's a real one and yours

DX1201Close.jpg


800-1732-Kentuckian-Full-Si.jpg


Your stock would need a lot of work plus you'd be missing the loading rod basket. (thing underneath)
 
ya...i suppose the cheaper way isnt always the better way..LOL:lol:

probably just breakdown and spend the 100 on ebay
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top