Speakers in Jango Helmet

asok

Well-Known Hunter
I have had some people ask me to post photo's of the speakers in my Jango helmet and tell how I did it so, here goes.

Parts used:
Radio Shack black amp
2 PC speakers
9 volt battery
Radio Shack mic Model: 33-3013
window screen
black thread and needle
neck seal - from BKBT, no longer made.

I took the RS amp out and put it into a smaller box like you would do for a TK. Then wired up 2 speakers again like you would do for a TK. Then took some window screen, left over from TK as well and made wrapped it around the speakers 2 times. Then sowed them to the bottom of my neck seal.

It is very simple and works well. The best part is that nobody sees it and with the speakers pointing down, the kids can hear you.

speakers.jpg
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top