Shane's Jango Build

That is where you probably got it too thick. If you keep on buffing it you should be able to get those to go away. Make sure that you really get it warmed up so that melts in your palm. Always apply a little at a time.
 
Hey I tried again today and got the same result. I applied very little and could not get that to go away. I must be missing something somewhere. If someone could just give me a rundown of how it should be applied that would be fantastic. I have already seen the youtube video as well.
 
That was where I messed up I watched a video where he put it on the armor first so thats what I did. Unfortunately it did not come off so I am going to have to sand it down then primer it then sand it again. Then once that is done I will put it on my hand first not the armor.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top