New Prototype BKBT Chest Armor

bigkidbiggertoys

Well-Known Hunter
Just thought I would post some pics of what I have been working on. These have been mostly finished for awhile except for the final smoothing. I still ned to cut chest slots in the left breast plate but I am going to mold & cast it as is so the filler doesn't break away. Constructive criticism is welcome.

ab plate.jpg


diamond.jpg


left plate.jpg


right plate.jpg


side view.jpg
 
I'll probably do a small LIMITED run of these but it won't be for awhile yet. I still need to copy the left breast plate so I can cut slots in it (it will be next to impossible to cut them cleanly in the prototype). There is some more final smoothing to do as well. I also need to make up a shoulder bell so I can have a complete upper armor set. There are no plans to do a backplate as these are so large that they are VERY expensive to ship. I am hoping to get some of this ready by Christmas.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top