My Right Jango Rocket Launcher

Thanks! Just don't ask if I am going to do the rest of the gauntlets. I just don't think I can.
 
why make a whole new one. I'm assuming the old plain one was resin? why not pencil out where you wanted your lines and taken a dremel to it? you totally could have modified it. :) on a side note, very nice replacement, lookin good. I notice you made it out of styrene? abs? either way dude, dump the epoxy. go to your local hardware store and ask for CA glue in a medium thickness and a bottle of spray accelerator. trust me, you'll be way happier on projects like that in the future :) nothin quite as fun as building stuff on your own :)
 
The old one was fiberglass and it was easier to make my own. I have got it cast and the dart as well. I have updated my web page as well. http://home.insightbb.com/~wlwarren/forsale/Jango/gauntlet/Right/RightGauntlet.html


pic8.jpg
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top