My Jango Shin WIP

tc2917

Active Hunter
Guys,
I need your keen eyes on this! I am working up my shin armor. I am going to attempt to get one piece done as close as I can get it and then cast a set from it.
Now I know that the top is obviously wrong depending on he leg it is on but my intent is to make those cuts after the pulls have been made.
What are your opinions on the over all shape and size????

100_0410.jpg

100_0411.jpg

100_0412.jpg

100_0413.jpg
 
..looks so far so good for me. but would prefer to see the result after your cut made....
 
Last edited by a moderator:
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top