Key hole question

Ok well im painting my helmet, and i just got done removing the fake plastic visor(rubies). will i didnt have my dremle, so i had to manualy saw it out:p . well i dont think thats an option with taking the key holes out, any ideas?:confused
Matt
 
If you don't have a dremel you should be able to drill a bunch of holes and cut chunks out then clean up the keyholes with a file.
 
HAHA:lol: i build modle cars all the time i dont know why i didnt think of the exacto knife...ok thanks. oh any ideas on the grate in the back?
 
Ok well im done now!SWEET hah couldnt find my exacto knife so i used some of my sharp would carving tools. worked like a charm. ill post a pic just for fun.8) thanks again everyone.
matt
edit: heres the pic
DSC01380.jpg
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top