Jango shoulder armour size question

rodsafett

Hunter
Howdo?

I have a set of Boba shoulder plates I want to cut down to use as Jango shoulder armour. Can someone please post up what the measurements across, point to point, etc, should be please? I am aware that there are different sizes as per height (Im 6 Foot) but is there a standard size guide I could use? Any help would be great and will allow me to get the dremell out and busy. No printer access so unable to use the Wizardofflight templates to help, hence my request for cold measurements

Thanks guys.

Rod
 
I don't recall the measurements, so I can't cite them from memory... with that said though, it would be difficult to alter a set of Boba shoulders as there is a radical difference in the shape/design. You would be better off to find some where to print off the WoF templates and make a set. With you being 6 foot, you'll need the templates at full scale.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top