Jango Knee Armour Sculpts

:lol:

I'm surprised you missed that. Of all people you have some of the best Hawk eyes here.

Slacking man. :lol:

Seeker
 
"Two complete knees". I'm going to sculpt one cetral piece, make a mould of it then cast two resin copies. This will then give me all the pieces needed to construct the knees and mould them as single items, just like my Boba knees.

DAZ

One question Daz, are you going to make two complete knees and then mould them, or just one frontal piece, and glue the sides on each set?
 
Not metal, but coldacst. It's a process of mixing aluminium powder with resin and then it can be polished to reveal the metal powder. This is how the screen used armour was made.

DAZ

Hi, I'm new here, but did you say you're making some out of metal?
 
Launchers are finished and the indents on the outer right knee are complete. Now I have to make the indents on the outer left knee section.

DAZ

Launchers.jpg
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top