Jango Holster Rig hardware ????

tc2917

Active Hunter
I need to order some of the brass hardware for my jango rig I am building. The first set of brass studs were to big and they look WAY OFF!:angry

Can someone hook me up where to get the correct ones and the size? Also what size punch do I need for holes?

100_0385.jpg

100_0386.jpg

100_0387.jpg

100_0388.jpg
 
Last edited by a moderator:
You won't find the correct studs at Tandy. I can find them locally and a few online stores carry them. I'm sure Cruzer can help you out better. As for punch size, I suggest just getting a rotary punch.
 
I appoligize for not replying to your PM a while ago. Just been busy with life, and forgot to reply after reading your PM as an email notice. Happens a lot these days.

Here's what I use:
I use the screw-in stud hardware from ohiotravelbag.com . The part #s are P-1700 and P-238-Sm (I think). I use a size #06 (3/16") punch for the stud holes. They have a $75 minimum order policy, so I can hook you up with a set (4 large & 2 small) that'll be enough for a whole holster assembly, if you want. $5 should cover the cost and shipping. Just let me know.

Looks like you're off to a good start there.(y)

DSC07376.JPG
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top