How to attach the Back Armor

thanks, that's a good idea. I might as well pick up the green bottle too since shipping's roughly $10 just for one little yellow bottle.
 
Yes excellent time for a revive on this thread.........it will come in handy for me in the near future. It has been bookmarked
 
I use a couple of drops of that exact color for initial attachment, and then surround the snap with a thick ring of the green label glue for extra strength, being sure to get it up on the sides as much as possible. I also use the accelerator spay to set everything quickly.

Devcon plastic weld would be my second choice if I didn't have Satellite City CA glue.
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top