Great!!! Another project

Chucko

Active Hunter
Just a little something I'm working on.

DSCF3998.jpg
 
Last edited by a moderator:
Hey Chucko, I found a place that has about 51 Sq Ft of Slate Grey (looks bluish) if you are interested... same place I got my vest material at and it is top notch.
 
Tony: I sent a pm about the leather.

A little update I just need to do the border stitch and get an elastic band. If I sale these it would be a limited run.

DSCF4003.jpg
 
Strange request for those intrested. I would need a traced outline of the bottom of the helmet. So I can try to get these to fit as good as possible. I own an ASOK bucket and I have access to a Fang. So for those with other makers I would need the hard copy not digital because I can not get my printer to print it out accurately.
 
How much are you planning to make these for? My helmet, being a scratch-built, would certainly need to be traced for you.
 
Saint: Time has been hard to come by lately but I'm still chipping away at yours.

Tampa: I'm still trying to locate a BM helmet outline
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top