Geting rid of the ring

BobaFettSlave1

Active Hunter
im thinking of modifying my MRs even further (now that i removed the plugs & hollowed out the fronts) by removing the stunt ring on the 2nd blaster. ide like it to look just like the opened one but have no clue how to do it without it looking like junk. should i have a machinist remove it? take my chances and dremel it, or should i just suck it up & leave it be? Anyone got any advice?
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top